How To Level A Uneven Floor For Laminate

Uneven timber upper floor due to masonry walls and sagging floor joists.

How to level a uneven floor for laminate.

Not only is trying to install laminate over an uneven subfloor difficult but also it can be dangerous. What can be done about uneven laminate locking floors. It s a bit confusing but a flat floor can still be slightly out of level and still create a good foundation for a long lasting floor installation. When you are dealing with uneven floors one option that you have is to use self leveling compound.

The floor can have an unlevel subfloor and still have a base for a nice laminate floor. The room has new plywood. Laminate floors aren t attached to the subfloor but subfloor preparation is as critical as it is when installing a nail or glue down floor. Laminate floor on uneven plywood subfloor.

First assess the severity of the uneven. Floors are rarely perfectly level. If the area is very large use a long straight 2 in 4 in 5 1 cm 10 2 cm board and set your level on top of it. Hi i am trying to lay 12mm laminate floor with 5m fibre wood underlay.

If not your floor covering which is the solid hardwood laminate tile or other exposed flooring that goes on top of the subfloor will never be flat and level this problem can be fixed but it all depends on exactly what kind of uneven subfloor you have. Hi there several of the internal walls at first floor level are masonry walls supported by the timber floor not sure if there. When they dry the surface will be perfectly flat and ready for the installation of the laminate floorboards. This compound can potentially be utilized on a concrete slab or a wood subfloor and it works well when you are dealing with dips in the floor.

Laminate flooring on an uneven subfloor can cause problems and needs to be addressed. If the floor is uneven lift up the board until it is level so you ll know how much flooring compound you ll need to even it out. A subfloor is meant to be flat and level. If the uneven floor is due to floor joists that have warped or twisted over time or were incorrectly installed the only way to level the floor is to remove the subflooring and shim the joists.