How To Fit A Toilet Pan To The Floor

If the toilet flange sits below the finished floor the toilet will leak.

How to fit a toilet pan to the floor.

In order for this not to happen the toilet flange must sit above the finished floor by at least 1 4. The first step in removing an old toilet is to turn off the water at the shutoff valve located either on the wall or floor behind or beside the toilet. That doesn t always provide a good enough bond to the floor. It s simple the watertight seal between the toilet bowl and wax ring will eventually fail.

Attach the water inlet pipe taking care not to overtighten. Steve used an oatey 4 replacement toilet flange for cast iron pipes. Fit a new seal around the drain hole in the floor and make sure it s tight. Diyers often set the toilet and then apply a tiny bead of caulk along the outside edge.

This video covers how to install a toilet. Fit the toilet to the soil pipe and push it back to the wall into place grab a pencil and mark on the floor where the holes are. Includes how to remove a toilet bowl or pan and cistern and install the new ones. To fit the toilet seat check out our toilet seat fitting guide.

To install a new toilet first turn off the water supply and remove the old toilet. Connect the pan to the waste pipe using the pan connector. Then lift the toilet onto the floor bolts and jiggle it a bit to seal the drainage hole. Make sure the seat can remain in an upright position.

To fit a toilet with l shaped clamps simply. How to attach them safely to the. Level the toilet base then tighten the bolts and cap them. Turn on the water and check for leaks.

Flush the toilet to drain all the water from the tank and toilet bowl. I can remember when i started my apprenticeship as a plumber every toilet pan was secured to the floor with a sand and cement mix mortar. We would place the toilet pan on the floor and mark out the foot print with a pencil and the remove it again the next step would be to cut a hole in the floor under the pan for a key this would create a lock between the pan and the floor. Screws are then fixed into these brackets from the outside.